Networking - EIGRP and OSPF
Networking - EIGRP and OSPF
21. Why does the data communication industry use the layered OSI reference model?
It divides the network communication process into smaller and simpler components, thus aiding component development, design, and troubleshooting.
It enables equipment from different vendors to use the same electronic components, thus saving research and development funds.
It supports the evolution of multiple competing standards and thus provides business opportunities for equipment manufacturers.
It encourages industry standardization by defining what functions occur at each layer of the model.
It divides the network communication process into smaller and simpler components, thus aiding component development, design, and troubleshooting.
It enables equipment from different vendors to use the same electronic components, thus saving research and development funds.
It supports the evolution of multiple competing standards and thus provides business opportunities for equipment manufacturers.
It encourages industry standardization by defining what functions occur at each layer of the model.
- 1 only
- 1 and 4
- 2 and 3
- 3 only
22. A receiving host has failed to receive all of the segments that it should acknowledge. What can the host do to improve the reliability of this communication session?
- Send a different source port number.
- Restart the virtual circuit.
- Decrease the sequence number.
- Decrease the window size.
23. What are the decimal and hexadecimal equivalents for the binary number 10110111?
- 69/0x2102
- 183/B7
- 173/A6
- 83/0xC5
24. What is the purpose of flow control?
- To ensure that data is retransmitted if an acknowledgment is not received.
- To reassemble segments in the correct order at the destination device.
- To provide a means for the receiver to govern the amount of data sent by the sender.
- To regulate the size of each segment.
25. Which three statements are true about the operation of a full-duplex Ethernet network?
There are no collisions in full-duplex mode.
A dedicated switch port is required for each full-duplex node.
Ethernet hub ports are preconfigured for full-duplex mode.
In a full-duplex environment, the host network card must check for the availability of the network media before transmitting.
The host network card and the switch port must be capable of operating in full-duplex mode.
There are no collisions in full-duplex mode.
A dedicated switch port is required for each full-duplex node.
Ethernet hub ports are preconfigured for full-duplex mode.
In a full-duplex environment, the host network card must check for the availability of the network media before transmitting.
The host network card and the switch port must be capable of operating in full-duplex mode.
- 1, 2, and 5
- 2 and 4
- 2, 3 and 4
- 5 only
26. Which of the following are types of flow control?
Buffering
Cut-through
Windowing
Congestion avoidance
Buffering
Cut-through
Windowing
Congestion avoidance
- 1 and 2
- 1, 3 and 4
- 2 only
- 3 only
27. Repeater spacing in point to point transmission using optical 1fiber is
- 2-10 KM
- 1-10 KM
- 10-100 KM
- 0-50 KM
28. The highest data rate is provided by the medium
- COAXIAL CABLE
- MICROWAVE
- TWISTED PAIRS
- OPTICAL FIBER
29. "The design issues of physical layer doesn’t deal with following characteristics"
- MECHANICAL
- ELECTRICAL
- FUNCTIONAL
- NONE